![]() ![]() Use a wet/dry vacuum to remove the remaining water out of pipe by placing the vacuum end over the filter hole. WARNING: To avoid water from becoming trapped between the floor suction fitting and the filter pipe. Step 6: Secure the cover to the spa utilizing the locking system. Do not reinstall until they are completely dry. Step 5: Remove filter cartridge and clean. Step 3: Remove the drain plug from the pump(s) and loosen all PVC pipe unions. Lower jets are any at or below the bench seat area. Step 2: Use a wet shop vacuum to vacuum the plumbing lines by placing the vacuum nozzle over each of the lower jet faces in the spa. This procedure will help prevent the growth of bacteria, algae and fungi in any areas of plumbing that may not be fully free of water after you drain your spa for its period of winterization. ![]() To winterize, follow these steps: WARNING: Prior to winterizing your spa, it will be necessary to Super Sanitize the spa water. When you are not planning to use the spa for six or more weeks, or when someone is not able to maintain the spa on a weekly basis, you should winterize the spa. Winterization of your spa is not generally necessary unless you plan to be away for an extended period of time. Therefore, if a technician comes out to remove the air lock, this is not covered under the labor portion of the warranty and any fees associated will be the responsibility of the spa owner. Air locks are not considered a defect and are a normal part of a fresh fill. ![]() Once the jets are functioning properly, tighten the nut back up and put the panel back on. Doing this will cause water to come out the nut you are loosening which is normal. Continue to loosen the nut until the jets begin to work. Take a large pair of channel locks and loosen either nut with the pump in high-speed. Once the panel is removed, locate the pump and you will see two large, white nuts attached to the pump. If this does not fix the issue you will have to open the access panel that houses the pump. If you still get an air lock the easiest way to remedy this situation is to repeatedly cycle between low- and high-speed on the topside controls. You can decrease the chances of getting an air lock by removing the filter and putting the hose down the opening. This type of damage is not covered under the warranty. If left un-attended, the pump and/or heater can overheat from lack of water flow. This is caused by the buildup of air in the plumbing lines which will not allow water or air to flow through the jets. Air locks are the most common occurrence when filling up a spa for the first time or refilling it for regular maintenance. If your spa is freshly filled but the pump isn’t pushing water through then you probably have an air lock. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |